category:Building materials / date:2022-05-20 00:51:40 / browse:385 / comment:6
Production process of stainless steel welded pipe: raw material - strip - welded pipe - end repair - polishing - Inspection (spray printing) - Packaging - shipment (warehousing) (decorative welded pipe). Series & mdash; martensitic precipitation hardening stainless steel pipe.LessbridgeMechanical properties when the steel or sample is stretched, when the stress exceeds the limit, even if the stress is no longer increased,Lessbridge304 stainless steel weir plate, the steel or sample continues to have obvious plastic deformation, and the small stress value when the yield phenomenon occurs is the yield point.Austenitic stainless steel has good resistance to uniform corrosion, but there are still the following problems in local corrosion resistance: intergranular corrosion of austenitic stainless steel. Austenitic stainless steel will have intergranular corrosion when it is kept warm at ~ ℃ or cooled slowly. The higher the carbon content, the greater the tendency of intergranular corrosion. In addition, intergranular corrosion also occurs in the heat affected zone of the weldment. This is due to the precipitation of Cr rich CrC on the grain boundary. The chromium poor area is formed in the surrounding matrix, which is caused by corrosion of the primary cell. This intergranular corrosion phenomenon also exists in the ferritic stainless steel mentioned above.Malmo,Application field: launch the market plan of stainless steel pipe in the target market of new products, such as stainless steel kitchen equipment.Model & mdash; The addition of sulfur improves the processability of the material.After that, the second widely used steel is mainly used in food industry, pharmaceutical industry and surgical equipment. Adding molybdenum makes it obtain a special corrosion-resistant structure. Because it has better chloride corrosion resistance than stainless steel pipe, it is also used as & ldquo; marine steel & rdquo;. SS is usually used in nuclear fuel recovery devices. Grade stainless steel Steel pipes usually also meet this application level.
Chloride ions exist in the service environment. Chloride ions exist widely, such as salt, sweat, sea water, sea breeze, soil, floating rust of iron foam and so on. Stainless steel corrodes rapidly in the presence of chloride ions, even more than ordinary low carbon steel. Therefore, there are requirements for the service environment of stainless steel, and it is necessary to remove dust frequently and keep it clean and dry. (in this way, the container leaks due to corrosion days after it is replaced with stainless steel.Process performance inspection: flattening test, tensile test,LessbridgeStainless steel pipe 201, impact test, flaring test, hardness test, metallographic test bending test and nondestructive testing (including eddy current testing, X-ray testing and ultrasonic testing).Low temperature embrittlement of stainless steel pipe --- in low temperature environment, the deformation energy is small. In low temperature environment, the phenomenon of reduced elongation and area shrinkage is called low temperature embrittlement. It is mostly produced on the body centered cubic structure of ferrite series.Trustworthy,Model & mdash; Martensite (high strength chromium steel), good wear resistance and poor corrosion resistance.In many construction sites we use this kind of welding for priming, which can effectively ensure its quality and has certain construction difficulties. Therefore,LessbridgeStainless steel 20 thick plate, careful and skilled welders should be selected for this work.Shape, stress, temperature and metal flow of forgings and dies. Results the multi-step upsetting extrusion process under high temperature can make the end of steel pipe meet the forming requirements. Conclusion the plastic forming process of steel pipe end is feasible, which has important reference significance for the improvement of pipe connection mode of railway freight car braking system.
share 6 Comments
Comment / Cancel reply