category:Building materials / date:2024-04-20 01:35:02 / browse:35 / comment:5
What are the uses of I-beam?Pass designSibovo,SibovoHow much is I-beam per square meter, there are many passivation methods for alloy tubes it has strong corrosion resistance.Generally, the common ones are high temperature passivation or sodium cyanide passivation.Takestan,The production process can be summarized as follows: pre leveling → finishing → straightening → post leveling. Flat steel / A / B steel with width of -, thickness of -, rectangular section and slightly pure edge. Flat steel can be finished steel, or it can be used as blank for welded pipe and thin slab for laminated thin plate.I-beam, whether ordinary or light, can only be directly used for bending members or lattice members on its Web because of its large and narrow section size and large moment of inertia difference between the two main axes on the section. It is not suitable for axial compression members and flexural members perpendicular to the web plane, so its application range is very limited. I-beams are widely used in buildings and other metal structures.Due to the relatively high and narrow section size of ordinary I-beam and light I-beam, the moment of inertia of the two main sleeves of the section is quite different, which makes it very limited in the scope of application. The use of I-beam shall be selected according to the requirements of design drawings.
After determining the reasonable pickling agent and polishing solution, it is very easy to carry out hot galvanizing for relevant alloy pipes. Use 'phosphating treatment' to degrease the pipes of electrolytic machine equipment, put them into the aqueous solution with zinc salt after pickling and passivation, put them into the cold-rolled steel plate in the direction corresponding to the pipes, and connect the switching power supply, If the current flows from the positive stage to the negative stage, a layer of zinc is deposited in the pipe.From the comparison of the monthly summary apparent consumption data information of galvanized pipe and the real estate sales data information from to this year, they show the consistency of height width ratio, which not only shows a positive correlation in the overall new trend, but also significantly conforms to the fluctuation direction of the monthly development trend. Judged as failing.Equipment maintenance,Application scope of alloy pipeApplication scope of alloy pipeI-beam: national standard * what is the wall thickness of I-beam
Because the section size of ordinary I-beam and light I-beam is relatively large and narrow, the moment of inertia of the two main shafts on the section is quite different which limits its application range. I-beam shall be selected according to the requirements of design drawings. In the structural design, the use of I-beam should be reasonably selected according to the mechanical properties, chemical properties, weldability and structural size of I-beam.supply,I-beam, whether ordinary or light, can only be directly used for bending members or lattice members on its Web because of its large and narrow section size and large moment of inertia difference between the two main axes on the section. It is not suitable for axial compression members and flexural members perpendicular to the web plane, so its application range is very limited. I-beams are widely used in buildings and other metal structures.The reinforcement mesh is used for embankment protection or for the protection of the whole riverbed and river bank, which is more suitable for the river channel with relatively gentle original bank slope. Taking the design dry water level as the boundary, the upper part is slope protection works and the lower part is foot protection works.All the cracks occur at -mm away from the edge below the alloy pipe, and the macroeconomic orientation is vertical to the cold rolling orientation,SibovoAlloy pipe for power plant, showing a 'high mountain' shape.Sibovo,I-beam, also known as steel beam, which limits its application range. I-beam shall be selected according to the requirements of design drawings. In the structural design the moment of inertia of the two main shafts on the section is quite different, the use of I-beam should be reasonably selected according to the mechanical properties, chemical properties, weldability and structural size of I-beam.
share 5 Comments
Comment / Cancel reply